2025-01-22
Pneumatic thin-film control valve production of standardized products, generally adjust the spring in the range of the standard grouping, that is, by the spring starting pressure Pi start, by the spring range Pr so that the spring produces a full distance deformation, and at the full distance such as the use of the regulator to master the output force is not available, so, in the installation of the regulator valve should be adjusted to meet the requirements of the process. Some use of the factory, due to the shortage of tuning common sense, inappropriate tuning, so that the valve is not closed, can not open, for this Shanghai Jin Gang Automatic Control Valve Co.
Pneumatic thin-film adjustment valve is the process of production automatic adjustment system in the nervous link. In order to its safe and peaceful operation, before installation and use or after inspection should be based on the reality of the need to carry out the necessary checks and judgments.
From the pneumatic control valve unconvincing force formula F↑ = π/4 (dg2△P + dsP₂) can be seen, when the pressure difference between the two ends of the control valve △P is large, its unconvincing force F↑ also increases, when the output force of the actuator is less than the unconvincing force, it can not be mastered in the full range of distance due to the journey, so in the actuator's output force is fixed, it should be limited to the work of the differential pressure, the differential pressure is known as the Allowable differential pressure (△P). If the actual differential pressure exceeds the allowable differential pressure of the regulating valve configured according to the specification, the exceeding value can be taken to change the preload of the compression spring to reach the goal of further improving the allowable differential pressure. This adjustment, can be installed before the process conditions based on calculations, based on the results of the calculations, through the adjustment pieces to change the spring preload to adjust the range of springs, adjusted and then installed to the process number. Doing so not only saves time to adjust and set up, but also to ensure that the process requirements.